YQL thermal fluid heater Introduction
YQL series gas and oil-fired thermal fluid heater adopts 3-trips round coil tube structure. The coil tube end adopts beam port to effectively protect the furnace all at boiler end, is equipped with advanced combustion device, and with fully automatic operation. After furl ignition from burner, it forms a flame full fill into the round furnace tube, and through the furnace tube wall, the heat is transferred by radiation, which is the first pass. The high temperature flue gas after combustion gathers at rear furnace door and then turns into the second trip, which is convection tube area. After convection heat exchange, the flue gas temperature is going lower and comes to front furnace door, and from here it turns into the third trip ether into the tube bundle area, then through economizer its emitted into atmosphere through chimney.
This type of heater is delivered in one whole body, and after erection at site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has 4 heating areas: furnace radiation heating area, the first convection tube heating area, the second convection tube heating area and economizer (waste heat boiler)
